Displayed Messages; Empty Grounds Container - DeLonghi ESAM04.350 Instructions For Use Manual

DISPlAYED MESSAGES

DISPlAYED MESSAGE
FILL TANK
ground Too Fine adJuST
Mill
inSerT WaTer SPouT

eMPTy groundS ConTainer

inSerT groundS ConTainer
add Pre-ground CoFFee
deSCale
leSS CoFFee
Fill BeanS ConTainer
inSerT inFuSer aSSeMBly
CloSe door
INSERT MILK CONTAINER
PreSS Clean
energy Saving
general alarM
eMPTy CirCuiT Fill CirCuiT
alternating with...
Hot water Press OK
POSSIBlE CAUSE
Insufficient water in the tank.
The grinding is too fine and the coffee is delivered too
slowly or not at all.
The water spout is not inserted or is inserted incorrectly.
The grounds container is full.
72 hours have passed since the first coffee after the
grounds container was last emptied.
after cleaning, the grounds container has not been
replaced.
The "pre-ground coffee" function has been selected
without placing any pre-ground coffee in the funnel.
The machine must be descaled.
Too much coffee has been used.
The coffee beans have run out.
The pre-ground coffee funnel is clogged.
The infuser has not been replaced after cleaning.
The service door is open
The milk container is not inserted correctly.
Milk has been delivered recently and the tubes inside the
milk container must be cleaned.
The function is active and reduces electricity consumption.
The inside of the appliance is very dirty.
The water circuit is emtpy
18
REMEDY
Fill the tank with water and/or insert it correctly, pushing it
as far as it will go until it clicks into place (fig. 3).
repeat coffee delivery and turn the grinding adjustment
knob one click clockwise towards "7" while the coffee mill
is in operation.
if after making at least 2 coffees delivery is still too slow,
repeat the correction procedure, turning the grinding
adjustment knob another click until delivery is correct.
insert water spout as far as it will go (fig. 4).
empty the grounds container and clean, then replace.
important: when removing the drip tray, the grounds
container MuST be emptied, even if it contains few
grounds. if this is not done, when you make the next
coffees, the grounds container may fill up more than
expected and clog the machine. (To ensure the 72 hours are
calculated correctly, the appliance must never be turned off
with the main switch in the 0 position.)
open the service door, remove the drip tray and insert the
grounds container.
Place pre-ground coffee in the funnel or deselect the
"pre-ground" function.
The descaling procedure described in the "descaling"
section needs to be performed as soon as possible.
Select a milder taste or reduce the quantity of pre-ground
coffee.
Fill the beans container
empty the funnel as described in the section "Cleaning the
pre-ground coffee funnel".
insert the infuser as described in the paragraph "Cleaning
the infuser".
Close the service door.
insert the milk container as far as it will go.
Press the "Clean" button and keep pressing until the
progress bar is complete. "Cleaning underway" is displayed.
disable the function from the menu (See section "energy
Saving").
Clean the inside of the appliance thoroughly, as described
in the section "Cleaning and maintenance". if the message
is still displayed after cleaning, contact a service centre.
Press OK button to deliver water from the spout until it
flows out normally.