HP OmniBook 900 Service Manual page 75

System Devices Menu
PS/2 Pointing Devices
Internal Pointing Devices
External Fn Key
IDE Controller
FDD Controller
Serial Port
Base I/O address
Infrared Port
Mode
Base I/O address
DMA channel
Parallel Port
Mode
Base I/O address
Interrupt
DMA channel
OmniBook 900†:
Audio
SB I/O address
WSS I/O address
AdLib I/O address
Interrupt
1st DMA channel
2nd DMA channel
Security Menu
User Password Is
Administrator Password Is
Set User Password
Set Administrator
Password
Smart Card Security
Boot
Resume
Undock
HP OmniBook 900
Sets whether internal pointing devices are automatically
disabled when an external PS/2 pointing device is detected, or
whether both internal and external devices are active. This is
required for the scroll wheel on a PS/2 mouse to function.
Enables one or both built-in PS/2 devices.
Sets whether left-CTRL + left-ALT on an external keyboard is
interpreted as the Fn key.
Enables the primary (hard drive) and secondary (optional CD-
ROM drive) controllers.
Enables the floppy drive.
Sets how the serial port is configured by the BIOS (specified
or automatic).
Sets the I/O address and interrupt.
Sets how the infrared port is configured by the BIOS (specified
or automatic).
Sets the hardware to support SIR (Standard IR), ASK IR
(amplitude shift keyed IR), or FIR (Fast IR) infrared
communications. (Driver installation required.)
Sets the I/O address and interrupt.
For Fast IR mode, sets the DMA channel.
Sets how the parallel port is configured by the BIOS (specified
or automatic).
Sets the port to normal, bidirectional, EPP, or ECP.
Sets the I/O address.
Sets the interrupt.
For ECP mode, sets the DMA channel.
Sets how the audio system is configured by the BIOS
(specified or automatic).
Sets the Sound Blaster I/O address.
Sets the Windows Sound System I/O address.
Sets the AdLib synthesizer I/O address.
Sets the interrupt.
Sets the DMA channel for playback.
Sets the DMA channel for recording.
Shows if a user password is set.
Shows if an administrator password is set.
Press ENTER to set, change, or clear user password.
Password length can be no longer than 8 characters, 0-9, A-Z,
and cannot include special or accented characters.
Press ENTER to set, change, or clear administrator password.
This password protects BIOS Setup settings. Password length
can be no longer than 8 characters, 0-9, A-Z, and cannot
include special or accented characters.
Available only if a smart card accessory is installed. Sets
whether the password is read from a smart card instead of
entered from the keyboard.
Sets whether a password is required when the computer
boots.
If boot security is enabled, sets whether a password is
required when resuming from a suspended state.
If boot security is enabled, sets whether a password is
required when undocking the OmniBook.
Troubleshooting and Diagnostics
Default
Auto
Both
Enabled
Both
Enabled
Enabled
3F8h, IRQ4
Disabled
SIR
2F8h, IRQ3
DMA3
Enabled
ECP
378h
IRQ7
DMA3
Enabled
220h
530h
388h
IRQ5
DMA1
DMA0
Default
Clear
Clear
Disabled
Enabled
Enabled
Disabled
3-25