Screw, M2.5×4mm
Reassembly Notes
To connect the flex cables, lay the keyboard upside-down on the front section of the top case.
Fold the keyboard back into place. Slip its front tabs into the slots, then snap the back edge into
place.
Push the keyboard toward the back as you tighten the two screws. This helps engage the tab at the
back-center of the keyboard.
HP OmniBook 900
Figure 2-7. Removing the Keyboard
Keyboard-screw
cover
Keyboard
Keyboard flex cable
Pointing stick flex cable
Removal and Replacement
2-13