Replacing Small Parts (User-Replaceable); Table 2-6. Replacing Small Parts (User-Replaceable) - HP OmniBook 900 Service Manual

Replacing Small Parts
(User-Replaceable)
The following small parts are user-replaceable.
Part
Battery panel
Bumper, display
(upper)
Cap, pointing stick
Cover, display screw
(lower)
Cover, hinge
Cover, keyboard
screw
Door, hard disk
Foot
HP OmniBook 900

Table 2-6. Replacing Small Parts (User-Replaceable)

Replacement Procedure
Remove the battery, then twist the upper edge of the panel off the battery.
Insert a small flat-blade screwdriver under the bumper and pry it loose. To replace,
firmly press the adhesive side of the bumper into the recess.
Pull the cap off the pointing stick.
Insert a small flat-blade screwdriver under the cover and pry it loose. To replace,
firmly press the adhesive side of the cover into the recess.
Put your finger above the F8 key and slide the keyboard-screw cover to the left about
3 mm (1/8 inch)—then lift off the cover. Open the display fully. Push in at the bottom-
front of the cover to unsnap it from the top case.
Put your finger above the F8 key and slide the keyboard-screw cover to the left about
3 mm (1/8 inch)—then lift off the cover.
Open the door about 45° and flex the door until one side tab releases.
Insert a small flat-blade screwdriver under the foot and pry it loose. To replace, firmly
press the adhesive side of the foot into the recess.
Removal and Replacement 2-9