Table of Contents
Advertisement
Item
Description
NIC link/activity
2
AMP status
3
Power cap
4
All other LEDs
—
Systems Insight Display LED combinations
When the health LED on the front panel illuminates either amber or red, the server is experiencing a health
event. Combinations of illuminated Systems Insight Display LEDs, the system power LED, and the health LED
indicate system status.
Systems Insight Display
LED and color
Processor (amber)
Processor (amber)
DIMM (amber)
DIMM (amber)
Over temp (amber)
Over temp (amber)
Fan (amber)
Fan (amber)
Power supply (amber)
Status
Off = No link to network. If the power is off,
view the rear panel RJ-45 LEDs for status
("Rear panel LEDs and
10).
Flashing green = Network link and activity
Solid green = Network link
Off = AMP modes disabled
Solid green = AMP mode enabled
Solid amber = Failover
Flashing amber = Invalid configuration
Off = System is in standby, or no cap is set.
Solid green = Power cap applied
Off = Normal
Amber = Failure
For more information on the activation of
these LEDs, see "Systems Insight Display
LED combinations (on page 8)."
Health LED
System power
LED
Red
Amber
Amber
Green
Red
Green
Amber
Green
Amber
Green
Red
Amber
Amber
Green
Red
Green
Red
Amber
buttons" on page
Status
One or more of the following conditions may
exist:
•
Processor in socket X has failed.
•
Processor X is not installed in the socket.
•
Processor X is unsupported.
•
ROM detects a failed processor during
POST.
Processor in socket X is in a pre-failure
condition.
One or more DIMMs have failed.
DIMM in slot X is in a pre-failure condition.
The Health Driver has detected a cautionary
temperature level.
The server has detected a hardware critical
temperature level.
One fan has failed or has been removed.
Two or more fans have failed or been
removed.
One or more of the following conditions may
exist:
•
Only one power supply is installed and
Component identification 8
Advertisement
Table of Contents
