Table of Contents
Advertisement
Hardware options installation
Introduction
If more than one option is being installed, read the installation instructions for all the hardware options and
identify similar steps to streamline the installation process.
WARNING:
internal system components to cool before touching them.
CAUTION:
beginning any installation procedure. Improper grounding can cause electrostatic discharge.
Processor option
This server does not support a three processor configuration.
WARNING:
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
CAUTION:
should attempt to replace or install the processor in this server.
CAUTION:
configurations must contain processors with the same part number.
IMPORTANT:
installing the processor.
To install a processor:
Power down the server (on page 18).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 18).
3.
Remove the access panel (on page 20).
4.
If any full-length expansion boards are installed, release the full-length expansion board retainer, and
5.
then remove the PCIe riser cage
Remove the air baffle (on page 23).
6.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, properly ground the server before
To reduce the risk of personal injury, electric shock, or damage to the equipment,
To avoid damage to the processor and system board, only authorized personnel
To prevent possible server malfunction and damage to the equipment, multiprocessor
If installing a processor with a faster speed, update the system ROM before
("Remove the primary PCIe riser
cage" on page 21).
Hardware options installation 34
Advertisement
Table of Contents
