Systems Insight Display Led Combinations - HP ProLiant DL388p User Manual

Systems Insight Display LED combinations

When the health LED on the front panel illuminates either amber or red, the server is experiencing a health
event. Combinations of illuminated Systems Insight Display LEDs, the system power LED, and the health LED
indicate system status.
Systems Insight Display
LED and color
Processor (amber)
Processor (amber)
DIMM (amber)
DIMM (amber)
Over temp (amber)
Over temp (amber)
PCI riser (amber)
Fan (amber)
Fan (amber)
Power supply (amber)
Power supply (amber)
Power cap (off)
Power cap (green)
Power cap (green)
IMPORTANT:
Test each bank of DIMMs by removing all other DIMMs. Isolate the failed DIMM by replacing
each DIMM in a bank with a known working DIMM.
Health LED System power
LED
Red Amber
Amber Green
Red Green
Amber Green
Amber Green
Red Amber
Red Green
Amber Green
Red Green
Red Amber
Amber Green
— Amber
— Flashing green
— Green
If more than one DIMM slot LED is illuminated, further troubleshooting is required.
Status
One or more of the following conditions may
exist:
•
Processor in socket X has failed.
•
Processor X is not installed in the socket.
•
Processor X is unsupported.
•
ROM detects a failed processor during
POST.
Processor in socket X is in a pre-failure
condition.
One or more DIMMs have failed.
DIMM in slot X is in a pre-failure condition.
The Health Driver has detected a cautionary
temperature level.
The server has detected a hardware critical
temperature level.
The PCI riser cage is not seated properly.
One fan has failed or has been removed.
Two or more fans have failed or been
removed.
One or more of the following conditions may
exist:
•
Only one power supply is installed and
that power supply is in standby.
•
Power supply fault
•
System board fault
One or more of the following conditions may
exist:
•
Redundant power supply is installed and
only one power supply is functional.
•
AC power cord is not plugged into
redundant power supply.
•
Redundant power supply fault
•
Power supply mismatch at POST or
power supply mismatch through hot-plug
addition
Standby
Waiting for power
Power is available.
Component identification 11