Install The Primary Pcie Riser Cage - HP ProLiant DL560 Gen8 User Manual

WARNING:
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
CAUTION:
remove all AC power cords before removing or installing the PCI riser cage.
Power down the server (on page 18).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 18).
3.
Remove the access panel (on page 20).
4.
If any full-length expansion boards are installed, release the full-length expansion board retainer.
5.
Remove the PCIe riser cage.
6.

Install the primary PCIe riser cage

WARNING:
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
Power down the server (on page 18).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 18).
3.
Remove the access panel (on page 20).
4.
To reduce the risk of personal injury, electric shock, or damage to the equipment,
To prevent damage to the server or expansion boards, power down the server and
To reduce the risk of personal injury, electric shock, or damage to the equipment,
Operations 22