Module Placement And Installation Rules; Examples, Module Placement In Matrix E7 Chassis - Enterasys MATRIX 7H4385-49 Hardware Installation Manual

Dfe-platinum series
Hide thumbs Also See for MATRIX 7H4385-49:
Table of Contents

Advertisement

Backplane Connections and Installation Rules
These DFE modules have connections to both FTM1 and FTM2 backplanes, enabling them 
to route frames between the two backplanes and all modules in the 6C107 chassis. 
However, the older first (6x1xx), second (6x2xx), and third (6x3xx) generation modules 
are still managed using their own Local Management and are not subject to management 
by the DFE module management entity.
The Matrix N1 (7C111), Matrix N3 (7C103) and Matrix N7 (7C107) chassis have only FTM2 
connections and support only DFE modules. The Matrix N5 (7C105‐P) has FTM2 
connections and also supports PoE‐compliant DFE modules.

Module Placement and Installation Rules

The DFE‐Platinum modules can be installed in a Matrix
Module Placement," below, for placement rules), Matrix N1, Matrix N3, Matrix N5, or 
Matrix N7 chassis. The Matrix N1, Matrix N3, Matrix N5, and Matrix N7 chassis support 
only DFE Series modules and there are no particular rules for installing modules.
Matrix E7 Chassis Module Placement
Depending on the modules being installed in the Matrix E7 chassis and to help ensure 
proper operation, consider the following examples and rules for module placement in the 
chassis. Figure
described below along with the applicable module placement rule.
Figure 3-1
7XXXXX
1 2 3 4 5 6 7
Example 1
Shows the chassis fully populated with DFE modules (7xxxxx). These modules 
communicate with each other via the FTM2 chassis backplane and act as a single 
switching entity with one IP address. The DFE modules are configured using a Command 
Line Interface set of commands.
Rule: DFE modules can be installed in any available chassis slot in the Matrix E7 chassis. 
3-4 Installation
3‐1 shows six examples of chassis module placement. These examples are 

Examples, Module Placement in Matrix E7 Chassis

A
B
6X3XX
1 2 3 4 5 6 7
(Figure
3-1,
A)
C
D
6X1XX
6X2XX
+
6X1XX
6X3XX 6X3XX
6X2XX
1 2 3 4 5 6 7
1 2 3 4 5 6 7
E7 (refer to "Matrix E7 Chassis 
E
7H43X-XX
6X2XX
6X1XX
6X2XX
6X3XX
7XXXXX
6X3XX
1 2 3 4 5 6 7
1 2 3 4 5 6 7
F
7XXXXX
6X1XX
6X3XX
6X3XX

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dfe-platinum series

Table of Contents