Installing The Network Expansion Module (Nem; Installing The Dimm - Enterasys MATRIX 7H4385-49 Hardware Installation Manual

Installing the DIMM

Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
To install a DIMM, refer to Figure
1. Insert the DIMM down between the connector fingers.
2. Pivot the DIMM downward so the tabs on the connector arms align with the two
alignment notches. With the two connector arms spread outward, push the DIMM
down between the connector arms. Then release the two connector arms to lock the
DIMM into place.
3. Reinstall the safety cover. Refer to "Reinstalling the Safety Cover" on page B‐13 for
instructions.
Figure B-8
1 DIMM
2 Connector fingers

Installing the Network Expansion Module (NEM)

Refer to Figure
1. Position the NEM so its front panel is under the edge of the DFE module front panel.
2. Align the two NEM connectors with the main board connectors. Then press straight
down over the two NEM connectors, applying pressure until they are properly
seated.
B‐8 and proceed as follows:
Installing the DIMM
Â
B‐9 and proceed as follows:
Ã
À
Á
Â
3 Connector arms
4 Alignment notches (2)
DFE-Platinum Series Hardware Installation Guide B-11
Gaining Access to Memory Modules
Ã