Installing The 7H4385-49 Into Matrix N1, N3, Or N5 Chassis - Enterasys MATRIX 7H4385-49 Hardware Installation Manual

Installing the 7H4385-49 into Matrix N1, N3, or N5 Chassis

Caution: Failure to observe static safety precautions could cause damage to the module.
Follow static safety handling rules and wear the antistatic wrist strap.
Do not cut the non-conductive bag to remove the module. Sharp objects contacting the
board or components can cause damage.
Precaución: Si no toma las medidas de seguridad necesarias para evitar descargas de
electricidad estática, es posible que el módulo se dañe. Siga los consejos de seguridad
para la manipulación del producto y no olvide utilizar la pulsera antiestática.
No corte la bolsa antiestática para sacar el módulo. Tenga en cuenta que si algún objeto
cortante entra en contacto con la placa o con los componentes, éstos podrían dañarse.
A DFE module can be installed in any available chassis slot (1 through 3) in the Matrix N3
chassis, or slots 1 through 5 in the Matrix N5 chassis, or into the single slot of the
Matrix N1 chassis. All chassis have horizontal slots for DFE modules. To install the
module into the Matrix N3, N5, or N1 chassis,
in "Preparing to Install into a Matrix
1. Prepare the DFE module using
Matrix
Caution: When setting the locking levers to the closed position, do not try to force the
locking levers to the point that they touch the face of the front panel. Forcing the locking
levers to this point could damage the module and chassis.
Precaución: Al mover las palancas a la posición de cerrado, tenga cuidado de no
llevarlas a un punto en donde estén en contacto con el panel frontal. Si lo hace, podría
dañar el módulo o el chasis.
Electrical Hazard: To prevent exposure to an energy hazard in a 7H4385-49 connected
to an external N-POE Power System, disconnect the 48-Vdc power cable from the 48-Vdc
input connector before servicing or removing the 7H4385-49.
Riesgo Eléctrico: Para prevenir la exposicion a un riesgo electrico en una tarjeta
7H4385-49 conectada a un sistema externo de energia N-POE Power System,
desconectar el cable de poder de 48-Vdc del conector de entrada 48-Vdc antes de dar
servicio o remover la tarjeta 7H4385-49.
Elektrischer Gefahrenhinweis: Um den Schutz vor el. Schäden des Moduls
(7H4385-49) zu gewähleisten, bei Verwendung der N-POE Systeme, sollte dies bevor
man dieses entnimmt oder Servicearbeiten daran vornimmt, vom 48-Vdc Stecker getrennt
werden.
2. Locate the chassis card guides that line up with the slot number in which the module
will be installed. Make sure the module locking levers are in the open position (top
and bottom).
E7, N1, N3, N5, or N7 Chassis" on page 3‐7.
Preparing to Install into a Matrix E7, N1, N3, N5, or N7 Chassis
refer to Figure
E7, N1, N3, N5, or N7 Chassis" on page 3‐7.
the procedure described in "Preparing to Install into a
DFE-Platinum Series Hardware Installation Guide 3-11
3‐3 and proceed as described