Applied Biosystems Data Explorer 4 Series User Manual page 68

Chapter 2 Using Chromatogram and Spectrum Windows
Parameter
Scaling Mode
Display Relative
Base Peak
2
Relative
Absolute Value
Display Min/Max
Minimum Absolute Max Y
Use Limit
Y Display Range
From/To
2-12 Applied Biosystems
5. Set the parameters described below as needed:
Autoscales the trace to the largest peak in the selected range.
Autoscales the trace to the base peak in the entire range, not the
selected range. Displays a right-axis label with the base peak
intensity.
NOTE: To turn off the right axis, select Graphic Options from
the Display menu, click the Graph #1 Setup tab, then deselect
the Show Right Y-Axis check box.
Sets the trace to the Y Display Range you enter in the Y Display
Range From/To boxes.
Sets the trace display to the minimum and maximum Y values.
Sets the minimum value for Y-axis scaling. Useful to maintain
relative scaling of peaks and to prevent autoscaling noise to full
scale.
Sets the range for scaling. If Display Relative or Base Peak
Relative is selected, range is in percent.
If Absolute Value is selected, range is in counts.
6. Click OK.
Description