Cable Assembly - Weider 8530 User Manual

During steps 13 to 25, refer to the CABLE DIA-
GRAM on page 19 of this manual. Identify the
three cables by their lengths, and note the posi-
tions of the cable traps. IMPORTANT: Do not over-
tighten the bolts and nuts securing the pulleys.
The pulleys must turn freely.
13. Locate the Medium Cable (58). Route the
Medium Cable around the indicated 3 1/2" Pulley
(15) attached to the Top Frame (55). Be sure
that the ball is on the indicated side of the
Pulley and that the Cable is between the
Pulley and the hook. Tighten the 3/8" x 3 3/4"
Bolt (88) and the 3/8" Nylon Locknut (not shown).
14. Wrap the Medium Cable (58) around a "V"-Pulley
(50). Attach the "V"-Pulley and a Long Cable Trap
(31) to the indicated bracket on the Front Upright
(42) with a 3/8" x 2 1/2" Bolt (86) and a 3/8" Nylon
Locknut (21). Be sure that the Long Cable Trap
is positioned to hold the Cable in place.
Route the Medium Cable (58) around the "V"-
Pulley (50) on the Left Arm (47). Be sure that the
Cable is in the groove of the Pulley and that
the Long Cable Trap (31) holds the Cable in
place. Tighten the 3/8" x 2 1/2" Bolt (86) and the
3/8" Nylon Locknut (not shown).
15. Route the Medium Cable (58) around the "V"-
Pulley (50) on the Right Arm (48). Be sure that
the Cable is in the groove of the "V"-Pulley
and that the Long Cable Trap (31) is posi-
tioned to hold the Cable in place. Tighten the
3/8" x 2 1/2" Bolt (86) and the 3/8" Nylon Locknut
(not shown).
Route the Medium Cable (58) around the
3 1/2" Pulley (15) attached to the Pulley Bracket
(20). Be sure that the Cable is in the groove of
the Pulley and that the Cable Trap (66) holds
the Cable in place. Tighten the 3/8" Nylon
Locknut (21) and the 3/8" x 2" Bolt (not shown).
Tighten the 5/16" x 5" Bolt (68) and the 5/16"
Nylon Locknut (not shown). Be sure that the
Pulley Bracket swivels freely.
16. Refer to the inset drawing. If the 3 1/2" Pulley
(15) is pre-attached to the Long "U" Bracket (57),
remove it. Wrap the Medium Cable (58) around
the 3 1/2" Pulley. Attach the Pulley and two Pulley
Covers (96) to the indicated hole in the Long "U"-
Bracket with a 3/8" x 2" Bolt (12) and a 3/8" Nylon
Locknut (21). Make sure that the Pulley Covers
are turned so the wide tabs are in the
6 o'clock position.
Be sure that the Cable is in the groove of the
Pulley and that the Cable and Pulley move
smoothly.
13
55
Ball
Hook
14
86
50
15
68
20
66
21
58
16
58
96
Wide
Tabs
21
9
58
88
15
86
58
31
31
50
Bracket
21
42
47
86
50
31
48
15
15
58
57
12
57