Weider 8530 User Manual page 10

17. Route the Medium Cable (58) around the 3 1/2"
Pulley (15) attached to the bracket on the Top
Frame (55). Tighten the 3/8" x 2" Bolt (12) and
the 3/8" Nylon Locknut (21). (Note: This Pulley is
pre-assembled. It has been shown disassem-
bled for easy part identification.) Be sure that
the Cable is in the groove of the Pulley and
that the Cable and Pulley move smoothly.
18. Remove the 3 1/2" Low Pulley (95) from the
Press Frame (17). Re-attach the Pulley with a
5/8" x 9/16" Spacer (7) between the Pulley and
the Press Frame. Finger tighten the 3/8"
Nylon Locknut (21).
Locate the Short Cable (23). Route the Short
Cable under the 3 1/2" Low Pulley (95) attached
to the lower hole in the Press Frame (17). Be
sure that the end of the Cable with the ball is
on the indicated side of the Press Frame and
that the Cable is between the Pulley and the
crossbar on the Press Frame. Tighten the 3/8"
Nylon Locknut (21).
If the indicated 3 1/2" Pulley (15) is pre-attached
to the Front Upright (42), remove it. Route the
Short Cable (23) around the Pulley. Attach the
Pulley and two Pulley Covers (96) to the lower
hole in the Front Upright with the 3/8" Nylon Jam
Nut (92), the 3/8" Flat Washer (9) and the 3/8" x
3 3/4" Bolt (88). Make sure the wide tabs of
the Pulley covers are in the 9 o'clock posi-
tion.
19. Route the Short Cable (23) around the 3 1/2"
Pulley (15) attached to the upper hole in the
Press Frame (17). Be sure that the Cable Trap
(66) is in the "3 o'clock" position and that
the Cable is routed around the Pulley as
shown. Tighten the 3/8" Nylon Locknut (21) and
3/8" x 3 1/2" Bolt (not shown).
If the indicated 3 1/2" Pulley (15) is pre-attached
to the Front Upright (42), remove it. Route the
Short Cable (23) around the 3 1/2" Pulley. Attach
the Pulley and two Pulley Covers (96) to the
upper hole in the Front Upright with the 3/8"
Nylon Jam Nut (92), the 3/8" Flat Washer (9)
and the 3/8" x 3 3/4" Bolt (88). Be sure that the
Cable is routed around the Pulley as shown
and that the wide tabs of the pulley covers
are in the 7 o'clock position.
20. Attach the end of the Short Cable (23) to the
Long "U"-Bracket (57) with a 1/4" Nylon Locknut
(2) and a 1/4" Flat Washer (10). Do not tighten
the 1/4" Nylon Locknut. It should be thread-
ed onto the Cable only a couple of turns.
17
55
21
18
42
92
9
19
42
92
9
17
20
2
10
10
12
15
Bracket
58
96
88
Wide
Tabs
23 9
15
Ball
Crossbar
17
23
88
15
96—Wide Tabs
15
21
66
12
9 3
6
57
23
88
7
95
21