Troubleshooting Guide - Royal Vacuum Cleaner Owner's Manual

TROUBLESHOOTING GUIDE

WARNING: TO REDUCE RISK OF PERSONAL INJURY - UNPLUG CLEANER BEFORE SERVICING
PROBLEM POSSIBLE REASON
Shampooer won't 1. Power cord not firmly plugged into
outlet.
run
2. Blown fuse or tripped breaker.
3. Needs service.
4. Thermal Protector activated.
1. Dirty Water Tank Door not installed.
Shampooer won't
pick-up or low 2. Dirty Water Tank is not installed
correctly.
suction
3. Dirty Water Tank is full.
4. Dirty water passage clogged.
5. Foam filter is dirty.
6. Brushroll worn.
7. Broken or worn belt.
1. Dirty Water Tank is full.
Water escaping
2. Dirty Water tank is not installed
from Shampooer
correctly.
3. Solution reservoir not installed
properly.
Shampooer won't 1. Solution reservoir not installed
properly.
dispense solution
2. Needs service.
1. Hose is clogged.
Cleaner attachments
won't pick up*
2. Hose inlet clogged.
3. Dirty Water Tank is full.
Cleaner attachments 1. Water supply hose not connected
properly.
won't spray*
Motor noise becomes
1. The float in the Dirty Water Tank
high-pitched has been activated.
* Not available on all models
ANY OTHER SERVICING SHOULD BE DONE BY AN AUTHORIZED SERVICE REPRESENTATIVE
CUSTOMER SERVICE (1-800-321-1134)
In the event that further assistance is required, see your Yellow Pages for an authorized Royal
our website at www.royalvacuums.com. Costs of any transportation to and from any place of repair are to be paid by
the owner. The service parts used in this unit are easily replaced and readily available from an authorized Royal
or retailer. Always identify your cleaner by the model number and manufacturing code when requesting information or
ordering replacement parts. (The model number appears on the bottom of the cleaner.)
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home. Replace
fuse/reset breaker.
3. Take to service center. To find nearest location,
visit our website at www.royalvacuums.com or
call 1-800-321-1134.
4. Allow cleaner to cool - Pg. 3.
1. Insert Dirty Water Tank Door - Pg. 9.
2. Review Placing Dirty Water Tank in base of
cleaner - Pg. 11.
3. Empty Dirty Water Tank - Pg. 10.
4. Clean Dirty Water Tank - Pg. 10.
5. Clean filter. Review Emptying & Cleaning the
Dirty Water Tank - Pg. 10 &11.
6. Replace brushroll - Pg. 12.
7. Replace belt - Pg. 12.
1. Emptying Dirty Water Tank - Pg. 10.
2. Review Placing Dirty Water Tank in base of
cleaner - Pg. 10, 11.
3. Review Review Solution Reservoir Installation -
Pg. 9.
1. Review How to Operate - Pg. 9.
2. Take to service center. To find nearest location,
visit our website at www.royalvacuums.com or
call 1-800-321-1134.
1. Remove hose and tools; remove obstruction -
Pg. 10.
2. Remove hose and clean inlet - Pg. 10.
3. Empty Dirty Water Tank - Pg. 10.
1. Connect trigger water supply connector and
base water supply connector - Pg. 9, 10.
1. Review Emptying & Cleaning the Dirty Water
Tank - Pg. 10 & 11.
® Dealer or visit
13
® Dealer