TOOL CADDY ASSEMBLY*
TOOL REQUIRED: PHILLIPS SCREWDRIVER
2.
1.
Align tabs on tool caddy
Place nut into recess on tool caddy and hold
with slots on midsection
into place (Diagram 2). Press handle release
and snap into place.
with your other hand to tilt the midsection
backwards (Diagram 2a).
4.
Hose Clip 2
Hose Clip 1
Upper
Lower
Cord
Cord
Clip
Clip
Wrap the cord around the upper and lower cord
clips.
8.
7.
Run the hose to the
Continue wrapping the
upper caddy and press
hose clockwise around
into hose clip #1 (See
the tool caddies, pressing
diagram 4).
the hose into the groove
on the bottom of the
lower tool caddy.
* Not available on all models
2a.
3.
Place screw through center of
lower midsection and tighten.
5.
6.
Slide the Upholstery/Stair
Clip the adapter end of the
Attachment into the middle
hose into the slot on the
slot of the lower tool caddy.
lower tool caddy.
9.
10.
Run the hose back to
Lock the attachment
the upper caddy and
end of the hose into
press into hose clip #2
place by pressing down
(see diagram 4).
onto the post located on
the right side of the
lower tool caddy, until
secure in place.
7