Emptying/Cleaning Dirty Water Tank; Attachment Usage; Storing Attachments; Dirty Water Tank & Filter: Emptying & Cleaning - Royal Vacuum Cleaner Owner's Manual

ABOVE FLOOR CLEANING/ATTACHMENTS: CONTINUED*

ATTACHMENT USAGE

1.
Turn power switch on.
While depressing
solution spray trigger,
push attachment
forward. Release trigger
and pull attachment
backward in the same
path to remove dirty
water and solution
from upholstery. (For
heavily soiled areas, repeat if necessary.)
NOTE: Do NOT oversaturate the upholstery.
IMPORTANT: FOR BEST CLEANING RESULTS
USE STEADY, MODERATE, FORWARD AND
BACKWARD MOTION. Make sure upholstery is
dry before use. NOTE: If the hose attachment
door is not replaced, there will be no suction
through the nozzle and the unit will not operate
properly.
DO NOT TRANSPORT THE SHAMPOOER WITH EITHER THE SOLUTION
RESERVOIR OR DIRTY WATER TANK FULL.
EMPTYING & CLEANING THE DIRTY WATER TANK
Your Carpet Shampooer is equipped with a shut off valve within your dirty water tank. When the dirty water tank
becomes full, the blue float (viewed from top of tank) will rise, shutting off the air flow thru the nozzle.
NOTE: The float in your Carpet Shampooer is the blue piece in the dirty water tank lid, and will shut off the suction
when the dirty water tank is full. For best results, use smooth, steady motion keeping the nozzle flat against the
carpeting. Tipping the cleaner and breaking the seal of the nozzle and carpeting will cause the float to rise and shut
off the suction. Once the float is activated, empty the dirty water tank. If the dirty water tank does not appear full,
turn the power switch off and wait for the float to settle and reset. If the float repeatedly shuts off the suction, empty
the dirty water tank. For best results, use only Royal
foam which will cause the float to rise prematurely and shut off the suction. Use five capfuls (5 ounces) of Royal
Carpet & Rug Shampoo per fill up of the clean water reservoir. A higher concentration of shampoo may cause
excessive foaming.
NOTE: You will hear a noticeable change in the pitch of the cleaner. This indicates a need to empty the dirty water tank.
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.
EMPTYING DIRTY WATER TANK
2.
1.
Grasp top of dirty water tank Grasp handle and pull tank
handle and push latch to out of base.
release.
STORING TOOLS CARRY HANDLE
1. 1.
Upholstery/
Stair Hose
Upholstery/
Stair
Attachment
Place hose and upholstery Grasp the carry handle
attachment into their storing on the front of the unit to
locations (page 7). Store for move unit from room to
next use. room.
* Not available on all models
® Carpet & Rug Shampoo. Other Solutions may generate excessive
3.
Remove dirty water tank lid.
10
®