Wireless Security Mode; Security Disabled - EnGenius 11N Wireless Gigabit Multi-Function Client Bridge User Manual

Multi-Function Gigabit Wireless-N Client Bridge Version 1.0
CTS Protection: CTS (Clear to Send) can be always enabled, auto, or disabled. By
enabled CTS, the Access Point and clients will will wait for a 'clear' signal before
transmitting. It is recommended to select auto.
Tx Power: You may control the transmit output power of the device by selecting a
value from the drop-down list. This feature can be helpful in restricting the coverage
area of the wireless network.
Click on the Apply button to save the changes.

3.2.5.4.4 Wireless Security Mode

Click on the Security link under the Wireless drop-down menu. To protect your
privacy this mode supports several types of wireless security: WEP WPA, WPA2,
and 802.1x RADIUS. WEP is the original wireless encryption standard. WPA
provides a higher level of security. The following section describes the security
configuration in detail.
3.2.5.4.4.1

Security Disabled

Click on the Security link under the Wireless drop-down menu.
ESSID Selection: As this device supports multiple SSIDs, it is possible to configure
a different security mode for each SSID (profile). Select an SSID from the drop-down
list.
Broadcast SSID: Select Enable or Disable from the drop-down list. This is the SSID
broadcast feature.
When this option is set to Enable, your wireless network name is
. If you're not using encryption then
broadcast to anyone within the range of your signal
they could connect to your network. When this is disabled, you must enter the
Wireless Network Name (SSID) on the client manually to connect to the network.
WMM: Choose to Enable or Disable WMM. This is the Quality of Service (QoS)
feature for prioritizing voice and video applications. This option can be further
configured in WMM under the Wireless drop-down menu.
Encryption: Select Disable from the drop-down list.
Click on the Apply button to save the changes.
40