EnGenius 11N Wireless Gigabit Multi-Function Client Bridge User Manual page 48

11n wireless gigabit multi-function client bridge
Hide thumbs Also See for 11N Wireless Gigabit Multi-Function Client Bridge:
Table of Contents

Advertisement

Multi-Function Gigabit Wireless-N Client Bridge
Version 1.0
Fragment Threshold: Packets over the specified size will be fragmented in order to
improve performance on noisy networks. Specify a value between 256 and 65535.
The default value is 2346.
RTS Threshold: Packets over the specified size will use the RTS/CTS mechanism to
maintain performance in noisy networks and preventing hidden nodes from
degrading the performance. Specify a value between 1 and 65535. The default value
is 2346.
Beacon Period: Beacons are packets sent by a wireless Access Point to
synchronize wireless devices. Specify a Beacon Period value between 20 and 1000.
The default value is set to 100 milliseconds.
DITM Interval: A DTIM is a countdown informing clients of the next window for
listening to broadcast and multicast messages. When the wireless Access Point has
buffered broadcast or multicast messages for associated clients, it sends the next
DTIM with a DTIM Interval value. Wireless clients detect the beacons and awaken to
receive the broadcast and multicast messages. The default value is 1. Valid settings
are between 1 and 255.
Data Rate: You may select a data rate from the drop-down list, however, it is
recommended to select auto. This is also known as auto-fallback.
N Data Rate: You may select a data rate for 802.11n from the drop-down list,
however, it is recommended to select auto. This is also known as auto-fallback.
Channel Bandwidth: You may select a channel bandwidth in order to improve the
efficiency of the network, however, it is recommended to select Auto 20/40MHz. This
is also known as auto-fallback.
Preamble Type: Select a short or long preamble. For optimum performance it is
recommended to also configure the client device as the same preamble type.
CTS Protection: CTS (Clear to Send) can be always enabled, auto, or disabled. By
enabled CTS, the Access Point and clients will will wait for a 'clear' signal before
transmitting. It is recommended to select auto.
Tx Power: You may control the transmit output power of the device by selecting a
value from the drop-down list. This feature can be helpful in restricting the coverage
area of the wireless network.
Click on the Apply button to save the changes.
48

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents