Table of Contents
Advertisement
Transparent mode installation
Using the setup wizard
FortiGate-800/800F Installation Guide
config system manageip
set ip 10.10.10.2 255.255.255.0
end
3
Confirm that the address is correct. Enter:
get system manageip
The CLI lists the management IP address and netmask.
To configure DNS server settings
1
Set the primary and secondary DNS server IP addresses. Enter
config system dns
set primary <address_ip>
set secondary <address_ip>
end
Example
config system dns
set primary 293.44.75.21
set secondary 293.44.75.22
end
To configure the default gateway
1
Make sure that you are logged into the CLI.
2
Set the default route to the default gateway that you recorded in
Enter:
config router static
edit 1
set dst 0.0.0.0 0.0.0.0
set gateway <address_gateway>
set device <interface>
end
Example
If the default gateway IP is 204.23.1.2 and this gateway is connected to port 2:
config router static
edit 1
set dst 0.0.0.0 0.0.0.0
set gateway 204.23.1.2
set device port2
end
From the web-based manager, you can use the setup wizard to begin the initial
configuration of the FortiGate unit. For information about connecting to the web-based
manager, see
"Connecting to the web-based manager" on page
01-28006-0024-20041026
Reconnecting to the web-based manager
Table 9 on page
16.
42.
45
Advertisement
Table of Contents
