Table of Contents
Advertisement
18
Note: The following procedure describes how to connect to the CLI using Windows
HyperTerminal software. You can use any terminal emulation program.
To connect to the CLI
1
Connect the serial cable to the communications port of your computer and to the
FortiGate Console port.
Use the RJ-45 to DB-9 convertor if your PC communications port requires a DB-9
connector.
2
Make sure that the FortiGate unit is powered on.
3
Start HyperTerminal, enter a name for the connection, and select OK.
4
Configure HyperTerminal to connect directly to the communications port on your
computer and select OK.
5
Select the following port settings and select OK.
Bits per second 9600
Data bits
Parity
Stop bits
Flow control
6
Press Enter to connect to the FortiGate CLI.
The following prompt is displayed:
FortiGate-800 login:
or
FortiGate-800F login:
7
Type admin and press Enter twice.
The following prompt is displayed:
Welcome !
Type ? to list available commands. For information about how to use the CLI, see the
FortiGate CLI Reference Guide.
8
None
1
None
01-28006-0024-20041026
Getting started
Fortinet Inc.
Advertisement
Table of Contents
