Table of Contents
Advertisement
NAT/Route mode installation
Using the web-based manager
Configuring basic settings
FortiGate-800/800F Installation Guide
PPPoE requires you to supply a user name and password. In addition, PPPoE
unnumbered configurations require you to supply an IP address. Use
record the information you require for your PPPoE configuration.
Table 7: PPPoE settings
User name:
Password:
You can use the web-based manager for the initial configuration of the FortiGate unit.
You can also continue to use the web-based manager for all FortiGate unit settings.
For information about connecting to the web-based manager, see
web-based manager" on page
After connecting to the web-based manager you can use the following procedures to
complete the basic configuration of the FortiGate unit.
To add/change the administrator password
1
Go to System > Admin > Administrators.
2
Select the Change Password icon for the admin administrator.
3
Enter the new password and enter it again to confirm.
4
Select OK.
To configure interfaces
1
Go to System > Network > Interface.
2
Select the edit icon for an interface.
3
Set the addressing mode for the interface.
Choose from manual, DHCP, or PPPoE.
4
Complete the addressing configuration.
•
For manual addressing, enter the IP address and netmask for the interface.
•
For DHCP addressing, select DHCP and any required settings.
•
For PPPoE addressing, select PPPoE, and enter the username and password and
any other required settings.
For information about how to configure these and other interface settings, see the
FortiGate online help or the FortiGate Administration Guide.
5
Select OK.
6
Repeat this procedure for each interface.
16.
01-28006-0024-20041026
Configuring basic settings
Table 7
to
"Connecting to the
29
Advertisement
Table of Contents
