Table of Contents
Advertisement
Configuration
(Standalone)
Manual Mode
Display
Reset Software
Load Factory
Defaults
Page 12 of 18
Set the product in the standalone Manual mode to control without a DMX controller.
·
Connect the product to a suitable power outlet.
Never connect a product that is operating in a standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
To enable the Manual mode, do the following:
1.
Press <MENU> repeatedly until nAn shows on the display.
2.
Press <ENTER> and Gobo, GoSP, diNN, or SHut show on the display.
3.
Use <UP> or <DOWN> to select the desired option as follows.
To select from the gobo rotation options:
1.
Select Gobo and press <ENTER>.
2.
Use <UP> or <DOWN> to select CU (gobo rotation), CCU (reverse gobo rotation),
or StoP (stop).
3.
Press <ENTER>.
To select the gobo rotation speed:
1.
Select GoSP and press <ENTER>.
2.
Use <UP> or <DOWN> to select 000—255.
3.
Press <ENTER>.
For dimmer control:
1.
Select diNN and press <ENTER>.
2.
Use <UP> or <DOWN> to select L000—L255 (0—100%).
3.
Press <ENTER>.
To set the shutter speed:
1.
Select SHut and press <ENTER>.
2.
Use <UP> or <DOWN> to select S000—S100 (0—20 Hz).
3.
Press <ENTER>.
You are able to flip the display for easy readability in any mounting situation.
To select your display angle:
1.
Press <MENU> repeatedly until diS (normal display) or rdiS (inverted display)
shows on the display.
2.
Use <UP> or <DOWN> to select the desired display.
3.
Press <ENTER>.
To reset the software in the Gobo Shot™ 50W IRC, do the following:
1.
Press <MENU> repeatedly until rESt shows on the display.
2.
Press <ENTER>.
To load the factory default settings in the Gobo Shot™ 50W IRC, do the following:
1.
Press <MENU> repeatedly until LoAd shows on the display.
2.
Press <ENTER>.
Gobo Shot™ 50W IRC User Manual Rev. 4
Advertisement
Table of Contents
