Mounting; Orientation; Rigging - Chauvet Gobo Shot User Manual

Mounting

Orientation

Rigging

Mounting Diagram
Gobo Shot™ 50W IRC User Manual Rev. 4
Before mounting the product, read and follow the safety recommendations indicated in
the Safety Notes.
The Gobo Shot™ 50W IRC may be mounted in any position; however, make sure
adequate ventilation is provided around the product.
·
Before deciding on a location, always make sure there is easy access to the product
for maintenance and programming.
·
Make sure that the structure or surface onto which you are mounting the product
can support the product's weight (see the
·
When mounting the product overhead, always use a safety cable. Mount the
product securely to a rigging point, such as an elevated platform or a truss.
·
When rigging the product onto a truss, you should use a mounting clamp of
appropriate weight capacity (you must supply your own mounting clamps). The
bracket has 13-mm holes, which are appropriate for this purpose.
·
When power linking multiple products, you must always consider the length of the
power linking cable and mount the products close enough for the cable to reach.
·
The bracket adjustment knobs allow for directional adjustment when aiming the
product to the desired angle. Only loosen or tighten the bracket knobs manually.
Using tools could damage the knobs.
·
The rubber feet also serve as floor supports. When mounting the product on the
floor, make sure that the product and cables are away from people and vehicles.
Mounting Clamp
(such as CLP-15 or
CLP-15N from
CHAUVET®)
Hanging/Mounting
Bracket
Rubber Feet
Technical Specifications).
Safety Cable
(such as CH-05 from
CHAUVET®)
Bracket
Adjustment
Knobs (2x)
Page 9 of 18