Table of Contents
Advertisement
4. O
PERATION
Control Panel
Operation
Menu Map
Configuration
(DMX)
Starting Address
Page 10 of 18
To access the control panel functions, use the four buttons located underneath the
display.
Button
<MENU>
Selects an operation mode or backs out of the current menu option
<UP>
Scrolls up the list of options or selects a higher value
<DOWN>
Scrolls down the list of options or selects a lower value
<ENTER>
Activates a menu option or a selected value
Main Function
Programming Levels
DMX Address
Manual Mode
nAn
Display
diS
Reset
Load
While in Manual mode (nAn), the Gobo Shot™ 50W IRC also responds to the IRC-6.
When using the IRC-6 in this mode, changes in programming levels and settings
will show on the display.
Set the product in DMX mode to control with a DMX controller.
1.
Connect the product to a suitable power outlet.
2.
Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a starting address that is too high, you could
restrict the access to some of the product's channels.
The Gobo Shot™ 50W IRC uses up to 4 DMX channels in its 4-channel DMX mode,
which defines the highest configurable address to 509.
If unfamiliar with DMX, download the DMX Primer from www.chauvetlighting.com.
To select the starting address, do the following:
1.
Press <MENU> repeatedly until d001—d512 shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select the starting address.
4.
Press <ENTER>.
Function
d001—d512
Selects the DMX starting address
StoP
Gobo rotation, stop
Gobo
CU
Gobo rotation
CCU
Reverse gobo rotation
GoSP
000—255
Gobo rotation speed
diNN
L000—L255 Dimmer (0—100%)
SHut S000—S100 Shutter (0—20 Hz)
diS
Normal display
rdiS
Reverse display
rESt
Resets fixture
LoAd
Loads factory defaults
Gobo Shot™ 50W IRC User Manual Rev. 4
Description
Advertisement
Table of Contents
