HP 200 Service Manual page 95

10 If you don't need to change the trailing
cable, but do need to remove it to access
other parts:
a Remove the two screws that attach the
trailing cable rear tray to the top of the
electronics enclosure.
Torx-20
c Remove the trailing cable bracket
screw from the cartridge carriage.
Torx-10
C3187 90000
b Carefully remove the right hand
cartridge spring from the cartridge
carriage.
Rear tray
d Pull the trailing cable up through the
slot at the top of the electronics
enclosure assembly and lift it, with rear
tray and bracket, from the plotter.
Rear tray
Bracket
Removal and Replacement 6 31