25 Set the carriage assembly upside down on a flat surface.
26 Using a small, standard screwdriver, remove the left and right belt clamps from the
carriage assembly.
C A U T I O N
Be careful not to damage the clamps.
Reassembling: Correctly install the
clamps, so that they don't fall out during
plotter operation!
27 Remove the main drive belt from the carriage assembly.
Calibration: After having reassembled the plotter, perform the cartridge alignment
routine D chapter 7.
6 54 Removal and Replacement
Belt clamp
Main drive belt
C3187 90000