Removing The Overdrive Roller - HP 200 Service Manual

Removing the Overdrive Roller

Overdrive roller
1 Remove the window D page 6 15.
2 Remove the center cover D page 6 16.
3 Remove the left endcover D page 6 18.
4 Lift the left front trim clear of the
plotter.
5 Remove the bail D page 6 56.
Note the position and orientation of the overdrive clutch. When correctly installed, the
overdrive roller can be manually rotated forward only.
7 While flexing the media separator upwards, slide the overdrive roller horizontally to the
right until the overdrive clutch and sideplate bushing can drop free of the roller.
Overdrive roller
6 60 Removal and Replacement
6 Remove the clutch retaining ring that
secures the overdrive clutch to the
overdrive roller.
You can do this with a needle nose pliers,
without having to remove the service
station. (The service station is not shown
in the diagram.)
Clutch retaining ring
Media separator
1
2
3
Sideplate bushing
Overdrive clutch
C3187 90000