HP 200 Service Manual page 137

5 On the right side, loosen the cam journal screw 12 turns counter clockwise and push the
screw in towards the center of the plotter.
Torx-8
6 Repeat the previous step and try to pull the cam journal and rear wire link
to the right and clear of the bar cam.
I unsuccHss ul, turn thH cam journal scrHw two morH turns
countHr clockwisH, push thH scrHw in towards thH cHntHr o thH
plottHr, and try again to pull thH journal and rHar wirH link
to thH right and clHar o thH bar cam. RHpHat thHsH actions
until succHss ul.
0D2 DmbtinJ: BH orH rHinstalling thH cam journal, tightHn thH
nut and scrHw just to thH point whHrH thH nut is insidH thH
journal. RHinstall thH journal and slightly tightHn thH scrHw.
Reassembling: Do not overtighten the cam journal screw. Doing
C A U T I O N
so could break the journal, cause the bar cam to enter the sideplate
hole, and thus restrict the action of the pinch arm lever.
C3187 90000
Cam journal screw
Cam journal
Rear wire link
Removal and Replacement 6 73