Repair Procedures
Removing the Electronics Enclosure Cover
1 Ensure that the plotter is switched off
and that the power cord and interface
cable(s) are not connected to it.
No interface
cables connected.
Power inlet: cord
not connected
3 Remove the screws that attach the
electronics enclosure cover to the
electronics enclosure.
zH
H
ha H
zH
H
ha H
or
Torx-20
C3187 90000
2 At the back of the plotter, ensure that
the two small wire clamps of the parallel
port are positioned vertically.
4 Gently lift open the electronics enclosure
cover to an angle of 45
c H
H c H
Flat
d
.
Removal and Replacement
6 5