Reading The Eerom Text Block - HP 200 Service Manual

Parameters Printed Below EEROM Text Block (Decimal Values)
See System Errors earlier in this chapter for correspondence of numbers to errors.
Calculated during bail calibration.
Whether the bench run has been performed or not.
X axis calibration = accuracy calibration
This is the drive roller correction factor, calculated during accuracy calibration.
The values in the formula are calculated during the setup sheet calibration.

Reading the EEROM Text Block

,
.
A
Example: Searching for the media sensor correction factor
1 The EEROM memory map Table 8 1 indicates that the memory address of the
media sensor correction factor is 1b.
2 The memory location key Table 8 2 indicates that address 1b is located in the second row
from the top, in the fifth column from the right.
3 On the sample EEROM text block Table 8 3 , address 1b contains the number 0.
Therefore, in this case, the media sensor correction factor is hexadecimal 0 = decimal 0 .
Number of times plotter has been switched on.
Y axis = carriage axis.
X axis = media axis.