Re Installing Teflon Washers - HP 200 Service Manual

Re installing Teflon Washers

Normally, you should not have to re install teflon washers on a DesignJet 200. Instead, you
should install a cam gear support and the associated parts as described later in this chapter.
The following note is given in case you need to reassemble the plotter while you wait for
these parts to arrive.
Problems can occur if the bail lift mechanism is too loose or too tight. Typically the number
of teflon washers to install is two. However, the ideal reassembly procedure is as follows:
1 Re install the lift mechanism using two washers.
2 With the engaging lever spring installed, press down on the lever and slowly let it rise.
3 If the lever does not completely lift up using the spring tension alone, remove one washer.
9 10 Product History and Service Notes
Teflon
Washers
C3187 90000