Removing The Y Tensioner And Housing - HP 200 Service Manual

Removing the Y Tensioner and Housing

1 Remove the window D page 6 15.
2 Remove the center cover D page 6 16.
3 Remove the left endcover D page 6 18.
4 Slide the cartridge carriage towards the
center of the plotter in order to access the
tensioner.
6 Remove the tensioner plate screw.
C A U T I O N
C3187 90000
5 Remove the screw that attaches the
trailing cable guide to the tensioner
housing.
Trailing-cable guide
Torx-15
The tensioner plate is under spring tension. Ensure that the plate does
not spring back suddenly. Hold the right end (viewed from the rear) of
the tensioner plate to keep the tensioner spring compressed.
Torx-15
Tensioner
housing
Removal and Replacement 6 45