Integrated Peripherals - ECS G33T-M2 User Manual

Integrated Peripherals

This page sets up some parameters for peripheral devices connected to the system.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Onboard Floppy Controller
Serial Port1 Address
Serial Port2 Address
Serial Port2 Mode
Parallel Port Address
Parallel Port Mode
ECP Mode DMA Channel
Parallel Port IRQ
SATA Configuration
HDA Controller
Onboard LAN Function
Onboard LAN Boot ROM
USB Functions
Legacy USB Support
Onboard 1394 Function
: Move
F1:General Help
OnBoard Floppy Controller (Enabled)
Use this item to enable or disable the onboard floppy disk drive interface.
Serial Port1/2 Address (3F8/IRQ4/2F8/IRQ3)
Use this item to enable or disable the onboard COM1 serial port, and to assign a port address.
Serial Port2 Mode (Normal)
If Serial Port 2 Address is not disabled, it allows you to set the Serial Port 2 Mode.
Parallel Port Address (378)
Use this item to enable or disable the onboard Parallel port, and to assign a port address.
Parallel Port Mode (ECP)
Use this item to select the parallel port mode. You can select Normal (Standard Parallel
Port), ECP (Extended Capabilities Port), EPP (Enhanced Parallel Port), or BPP (Bi-
Directional Parallel Port).
Parallel Port IRQ (IRQ7)
Use this item to assign IRQ to the parallel port.
ECP Mode DMA Channel (DMA3)
Use this item to assign a DMA channel to the parallel port.
SATA Configuration (Enhanced)
Use this item to show the Serial ATA Configuration options: Disabled, Compatible, En-
hanced.
HDA Controller (Enabled)
Use this item to enable or disalbe the High Definition audio device.
OnBoard LAN Function (Enabled)
Use this item to enable or disable the onboard LAN function.
Integrated Peripherals
Enabled
3F8&IRQ4
2F8/IRQ3
Normal
378
ECP
DMA3
IRQ7
Enhanced
Enabled
Enabled
Disabled
Enabled
Enabled
Enabled
Enter : Select
+/-/: Value F10: Save ESC: Exit
F9: Optimized Defaults
Using BIOS
Help Item
Allows BIOS to Enable
or disable Floppy
Controller.
33