Advanced Setup - ECS G33T-M2 User Manual

30

Advanced Setup

This page sets up more advanced information about your system. Handle this page with
caution. Any changes can affect the operation of your computer.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Thermal Management
Thermal Management
Limit CPUID MaxVal
Enhances Halt (C1E)
Intel XD Bit
Intel EIST
Quick Power on Self Test
Boot Up Numlock Status
APIC Mode
1st Boot Device
2nd Boot Device
3rd Boot Device
Hard Disk Drives
Removable Drives
Thermal Management (Enabled/TM1/TM2)
This item displays CPU's temperature and enables you to set a safe temperature to
Prescott CPU.
Limit CPUID MaxVal (Disabled)
This item can support Prescott CPUs for old OS. Users please note that under NT 4.0, it
must be set "Enabled", while under WinXP, it must be set "Disabled"
Enhanced Halt (C1E) (Enabled)
This item enables or disables enhanced halt (C1E).
Intel XD Bit (Disabled)
This item allows users to enable or disable the Intel XD bit.
Intel EIST (Enabled)
This item allows users to enable or disable the
technology.
Quick Power on Self Test (Enabled)
Enable this item to shorten the power on testing (POST) and have your system start
up faster. You might like to enable this item after you are confident that your system
hardware is operating smoothly.
Boot Up Numlock Status (On)
This item defines if the keyboard Num Lock key is active when your system is started.
APIC Mode (Enabled)
This item allows you to enable or disable the APCI (Advanced Programmable Interrupt
Controller) mode. APIC provides symmetric multi-processing (SMP) for systems, allowing
support for up to 60 processors.
Advanced Setup
Enabled
TM1/TM2
Disabled
Enabled
Disabled
Enabled
Enabled
On
Enabled
Maxtor 6V080E0
CD/DVD
1st FLOPPY DRIVE
Press Enter
Press Enter
: Move Enter : Select +/-/: Value
F1:General Help
F9: Optimized Defaults
Enhanced Intel SpeedStep
EIST(
Using BIOS
Help Item
For the processor its
CPUTD belows 0F14h.
TM2 only can be enable
under below settings.
1.Freq.>=3.6GHz FSB800
2.Freq.>=2.8GHz FSB533
F10: Save ESC: Exit