Web Interface Method - Dell Networking N4032 Configuration Manual

5. Apply power back to the mismatched stack member.
Allow the member a few minutes to load and join back into the stack. Run show switch again to validate
the configurations are in sync.
console#show switch
Management Standby
SW Status
--- ---------- --------- ------------- ------------- ------------- ---------
2 Stack Mbr
3 Stack Mbr
4 Mgmt Sw
Configuring a removed unit to be stand-alone
2.5.1.6
After removing a unit from a stack, the unit converts back to its original configuration that it had prior to
adding it to the stack, retaining the IP address, VLAN, LAG, and other settings. This allows immediate
access to the stand-alone through the out-of-band port if previously configured.
Note: A duplicate address could occur on the network if another device was assigned the IP address of
the device while it was a stack member. If this occurs simply detach the device from the network and
change the IP address through the console port.
Meta-data will remains on the switch until cleared or changes are made to the
affect functions of the switch. For example, a stand-alone switch is assigned to be unit #1. Upon joining
the stack it was assigned to be unit #3. When it is removed from the stack it will retain the assignment of
unit #3 until changed by the administrator. For instructions on how to make this change, see
Renumbering stack
2.5.2

Web interface method

Since any interface on the N4000 series switches can be used for stacking, make sure to verify exactly
which ports are being used for stacking so they are un-cabled and re-routed last, after the normal traffic-
passing cables have been re-routed. This information is found at System > Stack Management > Stack
Port Summary.
45 Stacking Dell Networking Switches: N4032, N4032F, N4064, N4064F
Preconfig
Status Model ID
Oper Stby N4032F
N4032
N4064
42.
on
Plugged-in Switch
Model ID Status
N4032F OK
N4032 OK
N4064 OK
Code
Version
6.0.1.3
6.0.1.3
6.0.1.3
stack
settings, but will not