Dell Networking N4032 Configuration Manual page 43

Type the switch renumber command to change the number of the switch.
console(config)#switch 3 renumber 2
The switch will be reset to perform unit renumbering
and the configuration of switch interfaces will be cleared.
Are you sure you want to renumber? (y/n)y
Allow a few minutes for the switch to renumber, then enter the following.
console#show switch
Management Standby
SW Status
--- ---------- --------- ------------- ------------- ------------- -------
1 Mgmt Sw
2 Stack Mbr
3 Unassigned
The switch that was Unit #3 is now Unit #2. Unit #3 is no longer present. To remove it from the list,
perform the no member command in Stack Configuration Mode.
console(config)#stack
console(config-stack)#no member 3
console(config-stack)#show switch
Management Standby
SW Status
--- ---------- --------- ---------- ----------- ----------
1 Mgmt Sw
2 Stack Mbr
Config Mismatch
2.5.1.5
A "Config Mismatch" in the Switch Status column indicates inconsistent entries in the "Preconfigured
Model Identifier" and "Plugged-in Model Identifier" columns. This usually occurs after a renumbering of
units when the stack consists of multiple models, but can also occur after a new unit is added to the stack
when the stack has been preconfigured and expects a different switch model. The command below
shows a Config Mismatch with a preconfigured model of N4032F and a plugged-in model of N4032 for
Unit 3.
console#show switch
Management Standby
SW Status
--- ---------- --------- ------------- ------------- ------------- -------
2 Stack Mbr
3 Stack Mbr
4 Mgmt Sw
43 Stacking Dell Networking Switches: N4032, N4032F, N4064, N4064F
Preconfig
Status Model ID
N4032
Oper Stby N4064
N4064
Preconfig
Status Model ID
N4032
Oper Stby N4064
Preconfig
Status Model ID
Oper Stby N4032F
N4032F
N4064
Plugged-in Switch
Model ID Status
N4032 OK
N4064 OK
Not Present
Plugged-in Switch
Model ID Status
N4032 OK
N4064 OK
Plugged-in Switch
Model ID Status
N4032F OK
N4032 Cfg Mismatch
N4064 OK
Code
Version
6.0.1.3
6.0.1.3
0.0.0.0
Code
Version
----------
6.0.1.3
6.0.1.3
Code
Version
6.0.1.3
6.0.1.3
6.0.1.3