Dell Networking N4032 Configuration Manual page 44

The plugged-in model will always be the actual model that is inserted as the stack unit. The preconfigured
model must be changed to show the same. To sync the two, the Unit must be temporarily removed from
the stack then added back. For this example, use the following steps to sync Unit 3.
Note: This example is for a Ring topology only and will not work on a Daisy Chain topology.
1. Save the configuration of the stack by using the "write" command.
2. Leaving all data cables plugged in, unplug the mismatched stack member's power cord.
3. From the command line type the following:
console#show switch
Management Standby
SW Status
--- ---------- --------- ------------- ------------- ------------- --------
2 Stack Mbr
3 Unassigned
4 Mgmt Sw
console#config
console(config)#stack
console(config-stack)#show supported switchtype
SID Switch Model ID
--- --------------------------------
1 N4032
2 N4032F
3 N4064
4 N4064F
console(config-stack)#no member 3
console(config-stack)#member 3 1
console(config-stack)#exit
console(config)#exit
console#write
This operation may take few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n) y
Configuration Saved!
console#show switch
Management Standby
SW Status
--- ---------- --------- ------------- ------------- ------------- ---------
2 Stack Mbr
3 Unassigned
4 Mgmt Sw
4. Notice the Preconfig Model ID has changed from N4032F to N4032.
44 Stacking Dell Networking Switches: N4032, N4032F, N4064, N4064F
Preconfig
Status Model ID
Oper Stby N4032F
N4032F
N4064
Preconfig
Status Model ID
Oper Stby N4032F
N4032
N4064
Plugged-in
Model ID
N4032F
N4064
 note that N4032 is a "1"
 use the "1" here to indicate an N4032
Plugged-in
Model ID
N4032F

N4064
Switch Code
Status Version
OK 6.0.1.3
Not Present 0.0.0.0
OK 6.0.1.3
Switch Code
Status Version
OK 6.0.1.3
Not Present 0.0.0.0
OK 6.0.1.3