SW
Status
--- ---------- --------- ----------- ----------- -------- -------
1
Mgmt Sw
2
Stack Mbr
3
Stack Mbr
4
Stack Mbr
The example above shows a new stack member (N4032) was added. The show switch stack-ports
command can also be used to see all of the ports that have been added to the stack as well as which ones
are being used for stacking.
If a switch (SW) number is configured prior to adding it to the stack and there are no other devices using
that number, then the switch continues to use the same number. Otherwise, the switch sets its number to
the lowest unassigned number upon joining the stack.
Note: Once added to a stack, a switch's out-of-band IP address and console port are no longer
accessible. Use the IP address and console port of the Master unit for management access, since the
stack now acts as a single large switch.
Repeat the above steps to add more new members to the stack.
26
Stacking Dell Networking Switches: N4032, N4032F, N4064, N4064F
Status
Model ID
N4064F
Oper Stby N4064
N4032
N4032
Model ID
Status
N4064F
OK
N4064
OK
N4032
OK
N4032
OK
Version
6.0.1.3
6.0.1.3
6.0.1.3
6.0.1.3