TFTP code transfer starting
12487236 bytes transferred...
File contents are valid.
Attempting to send the STK file to other units in the stack...
File transfer operation completed successfully.
Note: This procedure may take a few minutes longer than updating a single, non-stacked switch.
Perform another show version command to see the new firmware has been downloaded to all members
of the stack. Notice the firmware was only copied into the
console#show version
Image Descriptions
active :
backup :
Images currently available on Flash
unit
----- ------------ ------------ ----------------- -----------------
1
2
3
4
The next step is to activate the image that contains the new firmware by using the boot system backup
command.
console#boot system backup
Activating image backup ..
console#show version
Image Descriptions
active :
backup :
Images currently available on Flash
unit
----- ------------ ------------ ----------------- -----------------
1
2
32
Stacking Dell Networking Switches: N4032, N4032F, N4064, N4064F
active
backup
6.0.0.8
6.0.1.3
6.0.0.8
6.0.1.3
6.0.0.8
6.0.1.3
6.0.0.8
6.0.1.3
active
backup
6.0.0.8
6.0.1.3
6.0.0.8
6.0.1.3
Copying file to flash...
backup
current-active
6.0.0.8
6.0.0.8
6.0.0.8
6.0.0.8
current-active
6.0.0.8
6.0.0.8
image for each member.
next-active
6.0.0.8
6.0.0.8
6.0.0.8
6.0.0.8
next-active
6.0.1.3
6.0.1.3