Restore Point - Lexmark MS310 Manual

Lexmark MS31x/41x/510/610 & MX310/410/51x/61x Product Study Guide

Restore Point

Restore point is a new functionality similar to a PC's operating system restore. In the event that a new
firmware update causes problems in the printer, the administrator or customer can roll the printer back to
a previous state. All code is restored (RIP, Engine, etc.).
If restore point is used, you can "undo" the restore by holding the POR key sequence again.
Available on: POR Sequence
To go to the Restore Point, do the following:
4.3"and above
Touchscreen
Code level of EC1
and higher
For Training Purposes Only
1. Turn off the printer.
2. Press and hold 7 and 8.
3. Turn on the printer.
4. Release the buttons when the
splash screen appears.
Description
Important Information:
• Subsequent POR's boot to this
• If new code is flashed, that new
• Only 1 restore point is kept.
• If no code updates have occurred
• Only available on eTask machines.
71
Rev 1.3
restore point.
code becomes the boot point.
since the machine was built, there is
no restore point and the key
sequence is ignored.
4/21/2014