Cleaning The Printer; Lubrication Specification - Lexmark MS310 Manual

Lexmark MS31x/41x/510/610 & MX310/410/51x/61x Product Study Guide

Cleaning the printer

Warning! Damage to the printer caused by improper handling is not covered by the printer warranty.
1. Make sure that the printer is turned off and unplugged from the electrical outlet.
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock when cleaning the exterior of
the printer, unplug the power cord from the electrical outlet and disconnect all cables from the
printer before proceeding.
2. Remove paper from the standard bin and multipurpose feeder.
3. Remove any dust, lint, and pieces of paper around the printer using a soft brush or vacuum.
4. Dampen a clean, lint-free cloth with water, and use it to wipe the outside of the printer.
Warning! Do not use household cleaners or detergents to prevent damage to the exterior of
the printer.
5. Make sure all areas of the printer are dry before sending a new print job.
Note: You may need to perform this task after every few months.

Lubrication Specification

Lubricate only when parts are replaced or as needed, not on a scheduled basis. Use of lubricants other
than those specified in this service manual can cause premature failure. Some unauthorized lubricants
might chemically attack polycarbonate parts.
For Training Purposes Only 91
Rev 1.3
4/21/2014