Datamax RL3 User Manual page 5

Agency Compliance and Approvals
UL60950-1; 2nd Edition
CSA C22.2 No. 60950-1-07 2nd Edition
The manufacturer declares under sole responsibility that this product conforms to the following
standards or other normative documents:
Applicable Directive

Applicable Standards



The RL3 and RL4 printers with the 802.11 a/b/g and Bluetooth
compliant to the SAR requirements. The maximum SAR measured value was 0.572 W/kg averaged over 1 gram.
FCC Notice: (RL3 Printers)
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
FCC Notice: (RL4 Printers)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, it may cause harmful interference to radio communications. However there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

2004/108/EC, 73/23/EEC
RL3 Printers: EN55022 (2006) Class A; RL4 Printers: EN55022 (2006) Class B
EN55024 (1998), A1 (2001), A2 (2003)
IEC60950-1 (2005) 2nd Edition
®
wireless technology options has been found