Bgp Peer Group Settings - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Un Reachability Half
Life (1-45)
Route Map Action
Route Map Name
Action
IP Address
Netmask
Click the Apply button to accept the changes made for each individual section.

BGP Peer Group Settings

This window is used to create or delete a Border Gateway Protocol (BGP) neighbor.
To view the following window, click L3 Features > BGP > BGP Peer Group Settings, as shown below:
The fields that can be configured are described below:
Parameter
Peer Group Name
Action
IP Address
Remote AS Number
(0-4294967295)
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Delete All button to remove all the entries listed.
Click the View All button to display all the existing entries.
Click the View Detail link to view more information regarding the specific entry.
Click the Delete button to remove the specific entry.
Click the View Detail link to see the following window.
Enter the time (in minutes) after which the penalty of the unreachable routes will be
down, by half. The default setting is 15 minutes.
Use the drop-down menu to select between Route Map and Clear Route Map. Route
Map sets the dampening running configuration while Clear Route Map withdraws the
route map configuration.
Enter a route map name to be set or withdrawn. The default value is null.
Use the drop-down menu to clear the IP or Network address route dampening
information stored in the routing table.
Enter an IPv4 address to clear the dampening information.
Enter the netmask to clear the dampening information.
Figure 6-145 BGP Peer Group Settings window
Description
Select or enter the name of the BGP peer group.
Choose among None, Add, or Delete. None is the default.
Enter the IP address to be added or deleted.
Enter the number of the autonomous system to which the peer group belongs to.
285