Dvmrp Interface Settings; Dvmrp Routing Table - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide

DVMRP Interface Settings

This window is used to configure the DVMRP global state and allow the DVMRP to be configured for each IP
interface defined on the Switch. Each IP interface configured on the Switch is displayed in the below DVMRP
Interface Settings window.
To view the following window, click L3 Features > IP Multicast Routing Protocol > DVMRP > DVMRP Interface
Settings, as shown below:
The fields that can be configured are described below:
Parameter
DVMRP State
Interface Name
Click the Apply button to accept the changes made.
Click the Find button to find the interface entered.
Click the View All button to view all the interfaces configured on this switch.
Click the Edit button to re-configure the specific entry.

DVMRP Routing Table

This window is used to display DVMRP routing table on the Switch.
To view the following window, click L3 Features > IP Multicast Routing Protocol > DVMRP > DVMRP Routing
Table, as shown below:
The fields that can be configured are described below:
Parameter
Source IP Address
Source Netmask
Click the Find button to locate a specific entry based on the information entered.
Click the View All button to view all the interfaces configured on this switch.
Figure 6-99 DVMRP Interface Settings window
Description
Click the radio buttons to enable or disable the DVMRP state.
Enter the IP interface name of DVMRP. This must be a previously defined IP interface.
Figure 6-100 DVMRP Routing Table window
Description
Enter the IP address of the destination.
Enter the netmask of the destination.
256