Kenwood DNX570TR Quick Start Manual page 21

Installation Procedure
Supplied accessories
First of all, make sure that all
accessories are supplied with the
unit.
1 ...1
2 ...1
3 ...2
4 ...6
5 ...6
6 ...1
7 ...1
(5 m)
8 ...1
9 ...1
(3 m)
21
Unit
1 To prevent a short circuit, remove
the key from the ignition and
disconnect the
battery.
2 Make the proper input and
output wire connections for each
unit.
3 Connect the speaker wires of the
wiring harness.
4 Connect the wiring harness wires
in the following order;
ground, battery, ignition.
5 Connect the wiring harness
connector to the unit.
6 Install the unit in your car.
7 Reconnect the
battery.
8 Press the <Reset> button.
(P.4)
9 Perform the Initial Setup.
See First Step (P.6).
● Non-Japanese cars
DNX570TR
terminal of the
terminal of the
Bend the tabs of
the mounting
sleeve with a
screwdriver or
similar utensil and
attach it in place.
Continued