Gps Antenna - Kenwood DNX570TR Quick Start Manual

Quick Start Guide
● Toyota, Nissan or Mitsubishi car
4 (M5x6mm) or
5 (M5x7mm)
Car Bracket
NOTE
• Make sure that the unit is installed securely
in place. If the unit is unstable, it may
malfunction (eg, the sound may skip).
Trim plate
Attach accessory 6 to the unit.
GPS antenna is installed inside of
the car. It should be installed as
horizontally as possible to allow easy
reception of the GPS satellite signals.
To mount the GPS antenna inside
your vehicle:
4 (M5x6mm) or
5 (M5x7mm)
6
• Depending on the type of car, reception
• Please install this GPS antenna in an area
• The GPS antenna should be installed at
• Painting the GPS antenna with (metallic)
22

GPS antenna

1) Clean your dashboard or other
surface.
2) Remove the separator of the
metal plate (accessory 8).
3) Press the metal plate (accessory
8) down firmly on your
dashboard or other mounting
surface. You can bend the metal
plate (accessory 8) to conform to
a curved surface, if necessary.
4) Place the GPS antenna (accessory
7) on top of the metal plate
(accessory 8).
7
8
of the GPS satellite signals might not be
possible with an inside installation.
away from any antennas that are used
with CB radios or satellite televisions.
a position that is spaced at least 12 inch
(30 cm) from cellular phone or other
transmitting antennas. Signals from the
GPS satellite may be interfered with by
these types of communication.
paint may cause a drop in performance.