Standard Installation - SUPERLOLUX NI525A User Manual

NVR Software - Installation
3.2

Standard installation

The standard installation (= SeeTec Core Package) is suited for individual
workstations or host computers in distributed installation environments. It contains
the following modules:
 SeeTec 5 client
 SeeTec 5 server services
Installing the SeeTec 5 software
1. Insert the DVD-ROM into the DVD-ROM drive.
The Startup menu is displayed.
2. In this menu, select Install SeeTec 5 to install the SeeTec 5 software.
3. Optional: Change the path of the SeeTec Installation.
In 64-bit operating systems you can change the paths for the 32-bit and 64-bit
components.
4. Select Server and client installation in the dialog for choosing the setup
type to perform the standard installation.
5. Optional: Change the path of the administration database (MaxDB, database
for configuration and storage of system notifications). Select a path in the
SeeTec directory.
6. In the IP address/host name for server communication dialog in the
Found IP addresses/host names dropdown list, select the IP address that
the SeeTec services will connect to.
IPv6 addresses are currently not supported.
7. In the Default zone dialog, click on Configure zone.
8. In the Path field, select a path for the MultimediaDatabase (database for
image recording).
The default path for the MultimediaDatabase is: [SeeTec installation
directory]/re/md/mds/data.
9. Enter the size of the MultimediaDatabase in the Maximum size [GB] field.
10. If the zone is stored on a network drive, enter the complete UNC path.
11. If the network drive is protected by a user name and password, enter the
user name and password for accessing the drive under Network
authorization.
28
Note
Ensure that the user must be available on the local machine and the
domain and user name must be specified.