Table of Contents
Advertisement
Server
1. So that cameras start alarm recording or outputs in alarm case, you have to
edit the actions that should be executed at alarm start via Actions to
execute at the start of alarm.
In the subsequent dialog window, Action selection, all actions that can be
executed are listed.
Server actions
The following actions are available at the start of an alarm scenario:
Start alarm recording
Move to preset position
Close digital input
If images are recorded before the alarm is triggered, and if these images are saved,
it is easier to reconstruct how the activity unfolded that led to the alarm.
1. Optional: To save images for an alarm scenario that have been recorded
before the alarm was triggered, activate the Pre-alarm duration for
camera recording (s) option and enter a time range. In the Camera
configuration under Image recording, activate the standard recording to
transfer the saved images of the pre-alarm duration from the standard
recording to the alarm recording. If the standard recording is deactivated
and a pre-alarm duration is specified in the Camera configuration in the
Image recording dialog in the Alarm recording group box, the time range
of the pre-alarm duration is added to the alarm recording only.
The pre-alarm duration is limited to 3600 seconds.
2. Only for Motion JPEG recording:
If you want to record in a frame rate other than the one you have specified
in the point Image recording in the Alarm recording group box in
Camera configuration, you have to activate the Use special frame rate
(fps) for camera recording option and specify the desired frame rate.
3. To perform an action when an alarm ends, click on Edit and select the
corresponding action.
NVR Software - SeeTec Surveillance
115
Advertisement
Table of Contents
