If problems occur in the copied alarm scenario, an error report will be displayed. An
error report will be displayed, for instance, if different settings have been specified
for the original alarm scenario (= source alarm scenario) and the copied alarm
scenario (= target alarm scenario).
11. Adapt the alarm scenarios for which an error report is displayed.
5.2.10
Buttons
You can use buttons to start actions such as camera recordings, alarm scenarios or
to open doors.
Create button
1. To create a button, click on New.
2. Specify a name.
3. To change the button settings, click on Edit.
Defining general settings for buttons
Under General, you can change the name of the Button in the Name field, and its
icon in the Icon dropdown list.
In Surveillance Mode, Buttons are listed in alphabetical order in the Buttons pane.
To use a different sorting, select the desired position of the Button in the Use
custom sorting dialog.
1. To assign a hot key to the Button, activate the option Use hot key (enter
in the field below) and enter your shortcut. The following keys and
combinations of keys are already under use by SeeTec and may not be used:
ESC, F1, F8, F9, F11, F12, CTRL+ 0, 1, 2, 3, 4, 7, 8, 9, S, O.
2. If you select the Button is assigned to a camera option, the button is
shown only if you have previously selected the respective camera.
Selecting actions for Button
You can use buttons to start actions such as camera recordings, alarm scenarios or
to open doors.
Create button
1. To create a button, click on New.
2. Specify a name.
3. To change the button settings, click on Edit.
NVR Software - SeeTec Surveillance
121